Satel INTEGRA Plus Spezifikationen PDF herunterladen (Seite 68)

66 Programming SATEL

Communication RS – if this option is enabled, it is possible to connect a computer with

UARD

X program to the LCD keypad RS-232 port. The option is not available for the

INT-KSG and INT-TSG keypads.

Quick control [control 8#] – if this option is enabled, the O

UTS CONTROL

user function can be

started by pressing in turn the 8 keys (without the need to enter the user code).

Sound volume – the function enables the volume level of sound signal in the keypad to be

set. Available in the INT-KLCD, INT-KLCDR, INT-KLFR, INT-KSG and INT-TSG type

keypads.

Keypad zones – for each of the keypad zones can be defined whether it will be used or not.

Auto-backlight – the backlight can go on additionally after a specified event in the system:

starting the entry delay countdown in a selected partition or violating the selected zone.

In the case of the INTEGRA 256 Plus control panel, violation of the zone numbers

from 129 to 256 can turn on backlight in the INT-KLFR / INT-TSG keypads and

keypads with the following firmware version:

 INT-KLCD / INT-KLCDR – 1.12 (or newer);

 INT-KLCDK / INT-KLCDL / INT-KLCDS – 6.12 (or newer);

 INT-KSG – 2.00 (or newer).

State inspections – you can select which of the functions started by holding the number

keys will be available in the keypad.

Fig. 9. Keypad "State inspections" tab in D

LOAD

X program.

Permanently displayed partitions [State part.] – you can select the partitions whose state

will be permanently presented in the lower line of the display. Up to 16 partitions can be

selected. The partitions are displayed successively: for example, if the partitions 3, 6 and 7

are selected, their state will be displayed in the first, second and third position of the

display.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 81 82

Keine Kommentare

Satel INTEGRA Plus Spezifikationen Seite 68