Satel INT-KSG Bedienungsanleitung PDF herunterladen (Seite 9)

SATEL INT-KSG 7

4. Triggering the alarm from keypad

If your installer has enabled this feature, the alarms can be triggered from the keypad as

follows:

fire alarm – touch and hold the key for approx. 3 seconds;

medical (auxiliary) alarm – touch and hold the key for approx. 3 seconds;

panic alarm – touch and hold the key for approx. 3 seconds. The installer defines

whether the loud panic alarm (setting off the loud alarm signal) or the silent panic alarm

(without the loud signal) will be triggered.

5. Using selected user functions

All the user functions have been described in the INTEGRA or INTEGRA Plus control panel

user manual. Discussed below are just a few selected functions.

5.1 Changing code

1. Enter the code and confirm using .

2. Touch the 1 key to start the code changing function.

3. Enter the new code and confirm using or .

5.2 Zone bypassing

1. Enter the code and confirm using .

2. Touch the 4 key to display the contents of the Z

ONE BYPASSES

submenu.

3. Depending on whether the zone is to be inhibited or isolated, select the suitable function

NHIBIT

– the zone will remain bypassed until the partition to which it belongs is disarmed,

or until unbypassed by the user; I

SOLATE

– the zone will remain bypassed until

unbypassed by the user) and touch the

or key.

4. The zone list will be displayed graphically, each zone being represented by one of the

following symbols:

– the zone is not bypassed;

– the zone is inhibited;

– the zone is isolated.

Shown at the bottom of the display is the name of the zone currently indicated by the

cursor.

5. Using the arrow keys, move the cursor over the zone to be bypassed / unbypassed.

6. Touch any number key. The previously displayed symbol will be replaced with another

one. Touch the keys three times within 3 seconds: 0 – to display the

symbol for all

available zones, 1 – to display the or

symbol for all available zones (depending on

whether the function enables inhibiting or isolating the zones), and 2 – to invert the

symbols displayed so far.

7. Having selected the zones to be bypassed / unbypassed, touch the or key.

Bypassing the zones lowers the level of protection. Prior to arming, make sure that

there are no accidentally bypassed zones in the partition, which can allow an intruder

to gain access to the protected area, despite the partition is armed.

If a zone is bypassed, call the service immediately to repair the fault.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Satel INT-KSG Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ziffernblock Satel INT-KSG